Impact Socket for A series (pre A+/Verto) Flywheels and all swivel pin (ball joint) retaining nuts. See Tool13 for the Verto flywheel socket. Make life easier, get the right tool!
Impact Socket for A+/Verto Flywheels. See Tool03 for the early type of flywheel socket. Make life easier, get the right tool!
Tool for removing external door hinge bushings- tool15
17" long 11/16" or 17mm lug nut wrench fits classic Minis, Triumphs, Austin Healeys etc with 11/16" or 17mm hex lug nuts. Extra long for better leverage. Wheel nut wrench.
Clamp tool for rubber brake hoses. Perfect for stopping brake fluid draining whilst you change brake cylinders or calipers.
Two part primary gear oil seal tool, (known as clutch seal tool). It includes the sleeve that slides over the primary gear to protect the seal membrane on the gear splines, plus the outer body that pushes the seal home square. This is achieved by using the flywheel bolt in the end and tightening.
Flywheel puller tool for Classic Minis
This tool is required to compress the rubber cone spring on all Classic Minis. Early cars upto 1976 use standard thread and later cars use Metric thread. This tool does both. May vary slightly from photo depending on manufacturer.
Suspension tool used for removing and replacing the rubber cone springs or when replacing them with steel springs. This tool is for Metric only. For post 1976 Minis and springs that have been replaced since 1976. May vary slightly in appearance depending on manufacturer.