Blue Silicone Upper Radiator hose for Cooper S and 1275GT models. Fits all 1275's but may need to be trimmed for some.
Upper radiator hose for 1275GT models. Designed to be cut to fit for all 1275 models. Part# GRH469 can be shortened for use with other 1275 models to replace GRH247
Lower radiator hose for Mini and Moke without heater take off. Also available with Kevlar reinforcement, see GRH802Kevlar.
Kevlar reinforced lower radiator hose for Mini and Moke without heater take off. Bottom hose GRH802
Lower radiator hose for Mini and Moke without heater take off. 12A1551EVA or GRH802
Blue Silicone lower radiator hose for Mini and Moke without heater take off. Bottom hose GRH802S
GWP132 Water Pump with bypass for early cars with 850/998 engines. Short impeller type for early blocks. Mini, Spridget, Morris 1000. Gasket included.
Straight Kevlar Bypass Hose that goes from the water pump to the cylinder head on early series engines. Part # GZA2083, also replaces GZA2086(no longer available) but needs to be shortened for that application. Not for Cooper S, see part # AEG484.
Heater Cable, straight end, 30"
New heater matrix / heater core for 1970-1984 Minis. 2 plastic 5/8" outlets at each end The later HIF38 1275 and single point cars had a change point where the plastic outlets exited on the l/h. These units take 5/8" heater hose,
Picture loos similar but end pipes are not together. They are at each end.
25/40 (1"to 1.6") stainless steel worm drive radiator hose clamp. Fits all Mini radiator hoses and most MG, Triumph etc
JFF10003 Heater Cable, round end, 88 to 97 models with in-line heater valve.
From 1992 mini radiators were fitted with a push in thermal transmitter GVS104 and this is the clip to hold it and the seal in place. The rubber seal is available as CDU2334
PCF101240 radiator expansion tank for Minis with a front mounted radiator. Cap not included, see GRC1184
Radiator Bracket PCU10135 in Stainless Steel 1990-96
PEG10002 or PEM10036. 92 TO 1996 SANDWICH PLATE. SPI AND CARB MINIS. HAS TAPPED HOLE FOR RAD BRACKET STUD. NO SENDER HOLES. SPI MINIS USE WITH 12G103 TOP HOUSING, CARB MINIS USE WITH PEQ10010(THERMO SENDER HOLE AT FRONT).
Larger bore thermoatat housing, approx 32MM wide(1.250")and has a small outlet pipe which is blanked off (not drilled out). Uses GRH1140 Hose for PEQ10019 housing which is large bore one end and correct size at other end to fit the standard radiator size outlet. This larger bore housing is a usefull upgrade in hot climate countries. Dont forget to order the gasket!
One piece radiator cowl / shroud as fitted by Rover from 1974 on-this replaced the original 2 piece cowling pre 1974. The upper and lower fixings also changed
USED-PGX10001 radiator fan spacer. 7/16" thick (11mm). Used on most Minis after 1990 upto MPI models, also used on some earlier cars with a breather type timing cover. Used parts are sold as-is
GWP134 High Capacity Mini Water Pump with bypass. Gasket included.